Skip to main content
Version: 12 Dec 2024

1.11.0 OS Release Notes

Build B3E.241107.02-R.006​

This release builds upon the previous 1.10.0 release.

caution

USB Debugging and Developer Mode is disabled by default. After updating, please manually turn on Developer Mode using this guide.

Bug Fixes Features​

  • Improved handling of Spatial Anchor creation when multiple requests are made at once.

LED Changes​

No changes in this release

UX Changes​

No changes in this release

Known Issues​

Don’t forget: Some Magic Leap hardware and software features are in a pre-release state and might not be available, might contain bugs or defects, and might experience delays or failures. Read this document for guidance on the current state of Magic Leap hardware and software. This guidance helps developers make the best possible use of the Magic Leap platform.

  • Occasional Flickering in Applications after sleep cycle

    • There could be occasional blinking on some unity based applications after a sleep cycle. Recommended work around is to reboot the device.

  • Bluetooth Mouse not functional in Web Browser application

    • When a Bluetooth mouse is connected to the ML2 and the web browser application is used, the mouse cursor cannot be seen. Recommended workaround is to use other input methods for web navigation, like controller or hand/gesture, in place of a Bluetooth mouse.

Updating your device​

For instructions how to Update see the Updating Your Device guide on the Magic Leap Customer Care Page.

When flashing, you MUST flash in a linear sequence based on the build order in the table below which can be found on our Customer Care site under Magic Leap OS Update Path.

We recommend you to use ML Hub flashing capability to flash the OS. Contact your Magic Leap customer care representative for any additional support with regards to flashing your device.

Device Reset (Hardware Recovery)​

When device (wearable and/or compute pack appear frozen or unresponsive), use the following sequence to restart:

  1. Remove USB-C cable from the device
  2. Press and Hold the power button for at least 20 seconds
  3. Release the power button
  4. Wait a few seconds, then restart the device by tapping/releasing power button again.